No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage V100R006C20 Block Storage Service Planning Guide 05

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Ports on Nodes for Networking

Ports on Nodes for Networking

This section describes how to plan and use ports on nodes during installation and deployment of FusionStorage.

2288H V5 12-slot Nodes/2288H V5 16-slot Nodes

Figure 2-7 shows the ports on nodes for networking.
Figure 2-7  Ports on nodes for networking

Table 2-1 describes ports on compute nodes.
Table 2-1  Description of ports on compute nodes

Port Name

Port Type

Access Network Plane

Node Port Configuration Description

Switch Port Configuration Description

FPORT0 and SLOT3-0

10GE optical port

Storage plane

Connect to a storage switch. Two ports form a logical bond port (the bond mode is mode 1, that is, active-backup mode).

Configure a switch port as an access port.

FPORT1 and SLOT3-1

10GE optical port

Service plane

Connect to an aggregation switch. Two ports form a logical bond port (the bond mode is mode 1, that is, active-backup mode).

Configure a switch port as an access port.

NIC1

GE electrical port

Management plane

Connect to a BMC/management switch.

Configure a switch port as an access port.

Mgmt

GE electrical port

Management plane (BMC network)

Connect to a BMC/management switch.

Configure a switch port as an access port.

Table 2-2 describes ports on storage nodes.
Table 2-2  Description of ports on storage nodes

Port Name

Port Type

Access Network Plane

Node Port Configuration Description

Switch Port Configuration Description

FPORT0 and FPORT1

10GE optical port

Storage plane

Connect to a storage switch. Two ports form a logical bond port (the bond mode is mode 1, that is, active-backup mode).

Configure a switch port as an access port.

NIC1

GE electrical port

Management plane

Connect to a BMC/management switch.

Configure a switch port as an access port.

Mgmt

GE electrical port

Management plane (BMC network)

Connect to a BMC/management switch.

Configure a switch port as an access port.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100016635

Views: 4113

Downloads: 11

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next