No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage V100R006C20 Block Storage Service Software Installation Guide 07

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using PuTTY to Log In to a Node in Key Pair Authentication Mode

Using PuTTY to Log In to a Node in Key Pair Authentication Mode

Scenarios

After Secure Shell (SSH) security hardening is performed on nodes in the system, SSH-based password authentication is disabled for logins. In this case, use PuTTY and the required private key to log in to a target node.

Prerequisites

  • Security hardening has been performed for SSH on the target node. Security hardening measures include:
    • SSH key pair authentication mode has been enabled and the public key certificate has been configured on the node.
    • SSH password authentication has been disabled.
  • You have obtained the private key certificate matching the public key certificate.

Procedure

    1. Check whether PuTTY on the local PC has been used to log in to a node in key pair authentication mode.

      • If yes, go to 7.
      • If no or you cannot confirm, go to 2.

    2. Run PuTTY and enter the IP address of the target node and the SSH port number (default value: 22).
    3. In the Category area in the left pane, choose Connection > SSH > Auth.

      The SSH authentication configuration page is displayed.

    4. Click Browse, select the prepared private key certificate in the displayed window, and click Open.

      The file name extension of the private key certificate is *.ppk.

      The following figure shows the SSH authentication configuration page.
      Figure 9-1  Configuring the private key certificate

    5. In the Category area in the left pane, select Session.

      The main page is displayed.

    6. To facilitate subsequent access, create a custom session in Saved Sessions and click Save.

      The following figure shows the session configuration page.

      Figure 9-2  Saving a session

      After this step, go to 8.

    7. Select a saved session and click Load.
    8. Click Open.
    9. Enter the username for logging in to the target node as prompted.

      You are required to enter the certificate password if the in-use private key certificate is an encrypted certificate.

Translation
Download
Updated: 2019-06-29

Document ID: EDOC1100016637

Views: 23506

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next