No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionStorage V100R006C20 Block Storage Service Software Installation Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Server Using PuTTY Through a Network Port

Logging In to a Server Using PuTTY Through a Network Port


Log in to a server using PuTTY through an Ethernet port.



The PC is connected to the management network port of the server by a network cable.


Table 9-6 lists the data required for performing this operation.

Table 9-6  Data required for performing this operation



Example Value

Server IP address

Specifies the server IP address used for login from the PC.

This parameter is mandatory.


Specifies the username used for logging in to the server.

This parameter is mandatory.



Specifies the password used for logging in to the server.

This parameter is mandatory.



PuTTY is available. You are advised to download the latest version from its official website.


    1. Double-click PuTTY.exe.

      The PuTTY Configuration dialog box is displayed.

    2. Set the following login parameters:

      • Host Name (or IP address): Enter the IP address of the server.
      • Port: Set it to the default value 22.
      • Connection type: Select the default value SSH.
      • Close window on exit: Select the default value Only on clean exit.

      After setting Host Name, set Saved Sessions and save the settings. When you attempt to log in to the server through the network port next time, double-click the IP address saved in Saved Sessions.

    3. Click Open.

      The PuTTY window is displayed, providing a login as: text box for entering the username.

      • If you log in to the server the first time, the PuTTY Security Alert window is displayed. You can click Yes, which indicates that you trust this site, to enter the PuTTY operation window.
      • If you enter an incorrect username or password for more than four consecutive times, you must reconnect to PuTTY and log in to the server again.

    4. Enter the username in login as, and press Enter.
    5. Enter the password in Password, and press Enter.

      After you log in to the server, the host name of the server is displayed on the left of the command prompt.

Updated: 2019-06-29

Document ID: EDOC1100016637

Views: 29858

Downloads: 19

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next