No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Huawei SAP HANA Appliance Single Node Installation Guide (RH5885H and RH8100 V3+Broadwell+SLES) 12
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Bonded Network Ports

Configuring Bonded Network Ports

  1. On the Terminal CLI, enter yast2 and press Enter.

  2. Click Network Devices in the left pane and then Network Settings in the right pane.

  3. Select a 10GE network port to be bonded and click Edit.

  4. Select No link and IP Setup (Bonding Slaves) and click Next.

  5. Configure the other 10GE network port in the same way.
  6. Click Add.

  7. Select Bond from the Device Type drop-down list and click Next.

  8. Select Statically assigned IP Address, and enter the IP address, subnet mask, and host name.

  9. On the Bond Slaves tab page, select the target two network ports (one from each NIC), select mode=2 (or mode=balance-xor) from the Bond Driver Options drop-down list, and click Next.

    For the mode2 bonding mode, you need to configure stacking and trunks for the upperlink switch. You can change the bonding mode of the upperlink port depending on the switch configuration.

  10. Configure other bonded network ports as required in the same way, and click OK.

Updated: 2020-03-20

Document ID: EDOC1100017252

Views: 44694

Downloads: 130

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next