No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Huawei SAP HANA Appliance Single Node Installation Guide (RH5885H and RH8100 V3+Broadwell+SLES) 12
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Modifying the hosts File

Modifying the hosts File

Modify the hosts file to configure the resolution between the HANA host name and IP address.

  1. Run the vi /etc/hosts command to open the hosts file.

    hw00001: # vi /etc/hosts

  2. Enter i to go to the editing mode and add host name hw00001 behind field 10.5.1.10 hw00001 in the file, as shown in the following:

    Change the host names and IP addresses based on the actual situation.

    10.5.1.10  hw00001 hw00001

  3. Press Esc to switch to the CLI mode. Press : to go to the last line, enter wq, and press Enter.
Translation
Download
Updated: 2020-03-20

Document ID: EDOC1100017252

Views: 44453

Downloads: 126

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next