No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Huawei SAP HANA Appliance Single Node Installation Guide (RH5885H and RH8100 V3+Broadwell+SLES) 12
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Network Configuration

Network Configuration

  1. Open yast2 in Terminal as shown in Figure 5-55. Configure a network for the server, run the yast2 command, and press Enter, as shown in Figure 5-56.

    Figure 5-55 Open in Terminal

    Figure 5-56 Running the yast2 command

  2. In the dialog box that is displayed, as shown in Figure 5-57, choose Network Devices, and select Network settings in the right pane.

    Figure 5-57 Network Devices

  3. The Overview tab is displayed, Retain default value eth0 in Configuration Name, click Edit, as shown in Figure 5-58.

    Figure 5-58 Overview

  4. Edit statically assigned IP Address, clike Next, and OK in sequence, and close the YAST2 page, as shown in Figure 5-59.

    Use the parameters in Parameters to be Planned. Set the IP Address to 192.168.2.200 and Subnet Mask to 255.255.255.0. You can configure the IP address based on the actual condition.

    Figure 5-59 Network Card Setup

  5. Run the ifconfig eth0 command, and press Enter.

    If the information similar to that in Figure 5-60 is displayed, the network is configured successfully.
    Figure 5-60 Network configuration complete

  6. Run the rcSuSEfirewall2 stop command to disable the firewall, and press Enter.You can ignore this step if you stop the firewall in the installation.
  7. Connect a network cable to the first network port on the RH5885H /RH8100 V3 Broadwell. Use PuTTY to log in to the server. You can download PuTTY from chiark website. Run PuTTY and the PuTTY Configuration dialog box is displayed, as shown in Figure 5-61. Enter IP address and port then click Open.

    Figure 5-61 Connecting to the server

  8. Enter the user name and password (user root and its password of the OS) for login, and press Enter, as shown in Figure 5-62.

    Figure 5-62 Logging in to the server

Translation
Download
Updated: 2020-03-20

Document ID: EDOC1100017252

Views: 44190

Downloads: 124

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next