No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Huawei SAP HANA Appliance Single Node Installation Guide (RH5885H and RH8100 V3+Broadwell+SLES) 12
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Preparing for Installation

Preparing for Installation

  1. Select an installation mode.

    You can install an OS using physical DVD-ROM drive or virtual media (virtual DVD-ROM drive) of the virtual console.

    • Open the KVM console by following the steps in Preparations.
    • Insert the DVD into the physical DVD-ROM drive on the server (only when the server is started).
    Figure 5-1 Remote KVM page

    To ensure that the first boot option of the system is a DVD, perform the following operations in this section. If the first boot option of the system has been set to a DVD, go to section Installing an OS.

  2. Restart the system. Open the BIOS setup screen by 1 and 2, as shown in Figure 5-2.

    Figure 5-2 BIOS screen

  3. Select Boot using the rightward arrow on the keyboard, select Boot Option#1 using the downward arrow, and press Enter, as shown in Figure 5-3.

    Figure 5-3 Selecting Boot Option#1

  4. Press Enter. On the Boot Option #1 screen that is displayed, select starting with CDROM or DVDROM, press Enter, and then press Esc, as shown in Figure 5-4.

    After the BIOS is upgraded, the BIOS version may be changed, but starting with CDROM or DVDROM stays unchanged..

    Figure 5-4 Selecting CDROM or DVDROM

  5. On the displayed screen as shown in Figure 5-5, press F10. In the dialog box that is displayed, select Yes, and press Enter.

    Figure 5-5 Setting the boot option

Translation
Download
Updated: 2020-03-20

Document ID: EDOC1100017252

Views: 43699

Downloads: 124

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next