About This Document
Purpose
This document describes the software and hardware planning of the Huawei RH5885H V3/RH8100 V3 SAP HANA appliance, how to install a redundant array of independent disks (RAID) controller card, Redhat for SAP OS, Peripheral Component Interconnect Express (PCIe) solid-state drive (SSD), and SAP HANA database, and how to verify the installation.
By reading this document, audience can learn about the SAP HANA software and hardware, and how to install a RAID controller card, OS, PCIe SSD driver, and SAP HANA database in sequence (which cannot be changed).
Intended Audience
This document is intended for:
- Technical support engineers
- Maintenance engineers
- Users
Symbol Conventions
The symbols that may be found in this document are defined as follows.
Symbol |
Description |
|---|---|
|
Indicates an imminently hazardous situation which, if not avoided, could result in death or serious injury. |
|
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. |
|
Indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. |
|
Indicates a potentially hazardous situation which, if not avoided, could result in equipment damage, data loss, performance deterioration, or unanticipated results. NOTICE is used to address practices not related to personal injury. |
|
Calls attention to important information, best practices and tips. NOTE is used to address information not related to personal injury, equipment damage, and environment deterioration. |
Change History
Changes between document issues are cumulative. The latest document issue contains all the changes made in earlier issues.
Issue 09 (2019-06-13)
This issue is the ninth official release. Deleted the RHEL for SAP lifecycle model diagram from the RHEL for SAP Lifecycle.
Issue 08 (2019-05-10)
This issue is the eighth official release. Added RHEL for SAP Lifecycle.
Issue 07 (2019-03-28)
This issue is the seventh official release. Updated Problem Handling Process.
Issue 06 (2018-12-14)
This issue is the sixth official release. Added the content of Redhat7.3/Redhat7.4.
Issue 05 (2018-09-25)
This issue is the fifth official release. Some graphics are revised.
Issue 04 (2018-08-10)
This issue is the fourth official release. Added the section Registering and Activating the OS Subscriptions.
Issue 03 (2018-07-13)
This issue is the third official release. Refresh some command output.
Issue 02 (2018-05-15)
This issue is the second official release. Added the installation procedure of Redhat6.7.
Issue 01 (2016-7-11)
This issue is the first official release.
Previous
