No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

SUN2000-(29.9KTL, 33KTL-A, 36KTL, 42KTL) User Manual

This document describes the SUN2000-(29.9KTL, 33KTL-A, 36KTL, 42KTL) in terms of their installation, electrical connections, commissioning, maintenance, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting the Ground Cable (PE)

Connecting the Ground Cable (PE)

Prerequisites

The ground cable and OT terminal are available.
  • Ground cable: You are advised to use an outdoor copper cable with a conductor cross-sectional area greater than or equal to 16 mm2, and the conductor cross-sectional area should be greater than or equal to half of the conductor cross-sectional area of the AC output power cable.
  • OT terminal: M6

Context

  • The ground point on the enclosure is preferred to connect to the PE cable for the SUN2000.
  • The ground point in the maintenance compartment is used for connecting to the ground cable included in the multi-core AC power cable. For details, see Connecting AC Output Power Cables.
  • There are two ground points on the enclosure and one of them is standby.
  • It is recommended that the ground cable be connected to a nearby ground point. For a system with multiple SUN2000s connected in parallel, connect the ground points of all SUN2000s to ensure equipotential connections to ground cables.

Procedure

  1. Strip an appropriate length of the insulation layer using a wire stripper, as shown in Figure 5-3.

    Figure 5-3  Stripped length

  2. Insert the exposed core wires into the crimping area of the OT terminal and crimp them using hydraulic pliers, as shown in Figure 5-4.

    Figure 5-4  Crimping a cable
    NOTE:
    The cavity formed after the conductor crimp strip is crimped must wrap the core wires completely. The core wires must contact the terminal closely.

  3. Remove the ground screws from the ground points.
  4. Secure the ground cable using the ground screw and tighten the screw to a torque of 5 N•m using a security torx wrench.

    Figure 5-5  Connecting a ground cable
    NOTE:

    To enhance the corrosion resistance of the ground terminal, apply silica gel or paint on the ground terminal after connecting the ground cable.

Download
Updated: 2019-08-02

Document ID: EDOC1100019925

Views: 15131

Downloads: 6720

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next