No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

SUN2000-(29.9KTL, 33KTL-A, 36KTL, 42KTL) User Manual

This document describes the SUN2000-(29.9KTL, 33KTL-A, 36KTL, 42KTL) in terms of their installation, electrical connections, commissioning, maintenance, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the SUN2000

Installing the SUN2000

Procedure

  1. If the installation position is low and you can mount the SUN2000 onto the mounting bracket, go to 3 and then 5.
  2. If the installation position is high and you cannot mount the SUN2000 onto the mounting bracket, perform 3 to 6.
  3. Ensure that two people lift the SUN2000 and turn it upright. Lift the SUN2000 by grasping the handle at the bottom of the SUN2000 with one hand and the handle at the top with the other.

    To prevent personal injury caused by a falling SUN2000, keep balance when lifting the SUN2000 because it is heavy.

    Figure 4-15  Lifting a SUN2000

  4. Run a rope that is strong enough to bear the SUN2000 through the lifting eyes and hoist the SUN2000.

    When hoisting the SUN2000, keep balance to protect the SUN2000 from colliding with the wall or other objects.

    Figure 4-16  Hoisting a SUN2000

  5. Install the SUN2000 on the mounting bracket and level the SUN2000 chassis with the mounting bracket.

    Figure 4-17  Mounting the SUN2000 onto the mounting bracket

  6. Tighten the two security torx screws using a security torx wrench to a torque of 5 N·m.

    Figure 4-18  Tightening security torx screws

Download
Updated: 2019-08-02

Document ID: EDOC1100019925

Views: 14902

Downloads: 6704

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next