No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


SUN2000-(29.9KTL, 33KTL-A, 36KTL, 42KTL) User Manual

This document describes the SUN2000-(29.9KTL, 33KTL-A, 36KTL, 42KTL) in terms of their installation, electrical connections, commissioning, maintenance, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Closing the Maintenance Compartment Door

Closing the Maintenance Compartment Door


  1. Install the AC terminal cover.

    Figure 5-41  Installing a cover

  2. Adjust the support bar.

    Figure 5-42  Adjusting a support bar

  3. Close the maintenance compartment door. Tighten the two screws on the maintenance compartment door using a security torx wrench to a torque of 5 N·m.

    Figure 5-43  Tightening screws on the maintenance compartment door
    • If a screw on the maintenance compartment door is missing, use the unused ground screw on the chassis shell as a standby screw.
    • If the floating nut used for securing the maintenance compartment door is missing, use the standby floating nut shown in Figure 5-44.
    Figure 5-44  Removing a standby floating nut

Updated: 2019-08-02

Document ID: EDOC1100019925

Views: 15294

Downloads: 6745

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next