No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Alarms and Performance Events Reference 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ERPS_NOT_COMPLETE

ERPS_NOT_COMPLETE

Description

The ERPS_NOT_COMPLETE alarm indicates that the ERPS configuration is incomplete.

Attribute

Alarm Severity Alarm Type
Minor Equipment Alarm

Parameters

When you view an alarm on the network management system, select the alarm. In the Alarm Details field display the related parameters of the alarm. The alarm parameters are in the following format: Alarm Parameters (hex): parameter1 parameter2...parameterN. For details about each parameter, refer to the following table.

Name Meaning

Parameters 1–2

Indicate the ID of an ERPS instance.

Impact on the System

When this alarm is generated, ERPS does not take effect.

Possible Causes

Cause 1: The ERPS configuration is incomplete.

Procedure

  1. Cause 1: The ERPS configuration is incomplete.
    1. Check whether ERPS is correctly configured for all nodes on the physical ring. For details, see the ERPS.
    2. If ERPS is correctly configured, check whether the alarm is cleared. If the alarm persists, contact Huawei technical support engineers.

Related Information

NOTE:
The ERPS_NOT_COMPLETE alarm is not reported in the following cases:
  • The ERPS ring network is in the single-port state.
  • The ERPS ring node is in the forced switching (FS), signal failure (SF), or manual switching (MS) state.
  • The virtual channel is not enabled. After this alarm is reported, disable the virtual channel. The alarm is cleared.
Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020975

Views: 75191

Downloads: 138

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next