No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Alarms and Performance Events Reference 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MPLS_TUNNEL_LOCK

MPLS_TUNNEL_LOCK

Description

The MPLS_TUNNEL_LOCK alarm indicates that a command to lock the tunnel layer is issued on an MEP.

Attribute

Alarm Severity Alarm Type

Minor

Communication alarm

Parameters

None

Impact on the System

None

Possible Causes

The possible cause of this alarm is as follows:

Cause: A command to lock the tunnel layer is issued on an MEP.

As shown in Figure 4-19, a command to lock the tunnel layer is issued on MEP3 and MEP3 reports an MPLS_TUNNEL_LOCK alarm.

Figure 4-19  MPLS_TUNNEL_LOCK generation process

Procedure

  1. Cause: A command to lock the tunnel layer is issued on an MEP.
    1. Unlock the tunnel layer. For details, see Configuring LCK of MPLS-TP Tunnel OAM.
    2. Check whether the alarm is cleared. If the alarm persists, contact Huawei technical support personnel to handle the alarm.

Related Information

None

Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020975

Views: 75555

Downloads: 138

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next