No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Alarms and Performance Events Reference 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LPCSES

LPCSES

Performance Event Meaning

The LPCSES event indicates the lower-order path consecutive severe bit error second.

Performance Event Attributes

Performance Event ID Performance Event Type

0x97

SDH performance event

Impact on the System

If bit errors occur in the services, identify the causes and rectify the fault immediately. Otherwise, alarms will be generated and the signal transmission quality will be affected. If bit errors exceed the BIP bit error threshold-crossing threshold and degrade threshold, the BIP_EXC and BIP_SD alarms will be generated.

Possible Causes

When a consecutive LPSES sequence is detected, the LPCSES event occurs. When unavailable time comes or LPSES is absent in one second, the LPCSES sequence ends. When the service is at the VC-12 level, the first two bits of the V5 byte are verified. When the service is at the VC-3 level, the B3 byte is verified.

External causes:

  • The fiber performance is degraded, and the fiber has high attenuation.

  • The fiber connector is dirty or incorrect.
  • The equipment is poorly grounded.
  • A severe interference source is present near the equipment.
  • The working temperature is high or low, and the opposite equipment cannot tolerate such temperature.

Equipment problems:

  • The signal attenuation on the receive side of the line board is excessive, the transmit circuit at the opposite end is faulty, or the receive circuit at the local end is faulty.

  • The synchronization performance of the clock is poor.
  • The cross-connect unit and the line unit or the cross-connect unit and the tributary unit poorly match.
  • The tributary unit is faulty.
  • The board becomes faulty, or the performance of the board is degraded.

Relevant Alarms

Alarm Name Correlation

BIP_EXC

Indicates that the BIP bit errors cross the threshold when the service level is VC-12.

BIP_SD

Indicates that the BIP signal degraded when the service level is VC-12.

B3_EXC

Indicates BIP excessive errors when the service level is VC-3.

B3_SD

Indicates that the higher-order path (B3) signal degraded when the service level is VC-3.

LP_UNEQ

Indicates that the lower-order path is not equipped.

LP_TIM

Indicates that the lower-order path tracking identifiers mismatch.

TU_AIS

Indicates the TU alarm indication signal.

TU_LOP

Indicates the TU loss of pointer.

Procedure

  1. See LPES.

Reference

None.

Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020975

Views: 74845

Downloads: 136

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next