No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Alarms and Performance Events Reference 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
B1_EXC

B1_EXC

Description

The B1_EXC alarm indicates that the number of regenerator section B1 bit errors in signals received by the line board crosses the threshold.

Attribute

Alarm Severity Alarm Type

Minor

Service quality alarm

Parameters

None.

Impact on the System

The quality of transmitted services deteriorates severely, and the services on the optical port are unavailable.

Possible Causes

Possible causes of this alarm are as follows:

  • The threshold of regenerator section B1 bit errors is set to a small value.
  • Fiber connectors are loosely connected, resulting in serious attenuation of received signals.
  • The clock source is incorrectly configured or the performance of the cross-connect and timing units deteriorates.
  • The line board of the transmit unit at the opposite end is faulty.
  • The line board of the receive unit at the local end is faulty.

Procedure

  1. On the U2000, check whether the threshold of regenerator section B1 bit errors is set to a small value.

    If... Then...

    The threshold is set to a small value

    Set the threshold of regenerator section B1 bit errors to the default value. Then, check whether the alarm is cleared. If the alarm persists, go to the next step.

    The threshold is set to an appropriate value

    Go to the next step.

  2. Check whether the receive optical power is normal.

    If... Then...
    The receive optical power is two low Ensure that optical cables are intact, fiber connectors are clean, and the transmit optical power of the line board at the opposite end is normal. Then, check whether the alarm is cleared. If the alarm persists, go to the next step.
    The receive optical power is normal Go to the next step.

  3. Check whether the clock source is correctly configured and whether the performance of the cross-connect and timing units deteriorates at the local end.

    If... Then...
    The clock source is incorrectly configured Change or re-configure the clock source. Then, check whether the alarm is cleared. If the alarm persists, go to the next step.
    The performance of the cross-connect and timing units deteriorates Replace the system control, cross-connect and timing board. Then, check whether the alarm is cleared. If the alarm persists, go to the next step.
    The clock source is correctly configured and the performance of the cross-connect and timing units does not deteriorate Go to the next step.
    Replacing the system control, cross-connect, and timing board interrupts services. Exercise caution when performing this operation.

  4. Perform a self-loop at the local end. If bit errors are eliminated, the line board at the opposite end is faulty. Replace the faulty line board. If bit errors increase, the line board at the local end is faulty. Replace the faulty line board.

Related Information

None.

Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020975

Views: 75084

Downloads: 138

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next