No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Alarms and Performance Events Reference 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MPLS_TUNNEL_SD

MPLS_TUNNEL_SD

Description

The MPLS_TUNNEL_SD alarm indicates that the tunnel signal degrades. This alarm is reported when the CC packet loss ratio is higher than the SD threshold but is lower than the SF threshold.

Attribute

Alarm Severity Alarm Type

Major

Communication alarm

Parameters

None.

Impact on the System

The quality of service degrades and a small number of packets are lost.

Possible Causes

Possible causes of the MPLS_TUNNEL_SD alarm are as follows:

  • An excessive number of bit errors occur.
  • The bandwidth of the tunnel is exhausted.
  • Another service carrier layer is faulty.

Procedure

  1. On the U2000, check whether an alarm indicating excessive bit errors is reported. If yes, clear the alarm. Check whether the MPLS_TUNNEL_SD alarm is cleared.
  2. If the MPLS_TUNNEL_SD alarm persists, go to 3.
  3. On the U2000, check whether the allocated bandwidth is exhausted. If yes, expand the bandwidth allocated to the tunnel or eliminate the source that transmits a large amount of invalid data. Check whether the MPLS_TUNNEL_SD alarm is cleared.
  4. If the MPLS_TUNNEL_SD alarm persists, go to 5.
  5. On the U2000, check whether another service carrier layer, such as the Ethernet layer, is faulty. If yes, rectify running exceptions of the MPLS OAM protocol or setting inconsistency.

Related Information

None.

Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020975

Views: 74893

Downloads: 136

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next