No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Alarms and Performance Events Reference 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
TU_AIS

TU_AIS

Description

The TU_AIS alarm is a TU alarm indication signal. If a board detects that the signals in the TU path are all "1"s, the TU_AIS alarm is reported.

Attribute

Alarm Severity Alarm Type

Major

Communication alarm

Parameters

None.

Impact on the System

When the TU_AIS alarm occurs, the service in the alarmed TU path is interrupted. If the service is configured with protection, the protection switching is also triggered.

Possible Causes

Possible causes of the TU_AIS alarm are as follows:

  • Configuration data is incorrect.
  • The line is faulty.
  • The board at the opposite end is faulty.
  • The board at the local end is faulty.

Procedure

  1. Check whether SDH services are correctly configured. If the configuration is incorrect, modify it. If the configuration is correct, go to 2.
  2. Check whether line alarms that cause AIS insertion are reported on the service trail. If these alarms exist, clear them. If these alarms do not exist, go to 3.
  3. Check whether the fault occurs on the local or peer NE. If the fault occurs on the peer NE, go to 4. If the fault occurs on the local NE, go to 5.
  4. Replace the faulty board on the peer NE. If the alarm persists, go to 6. If the alarm is cleared, no further action is required.
  5. Replace the board on the local NE where the line unit resides. If the alarm persists, go to 6. If the alarm is cleared, no further action is required.
  6. Replace the board that reports the alarm. If the TU_AIS alarm persists, contact Huawei technical support engineers to handle the alarm.

Related Information

Table 4-5  Alarms that may cause the TU_AIS alarm
R_LOS R_LOF AU_AIS
AU_LOP HP_LOM -
Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020975

Views: 75800

Downloads: 138

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next