No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Alarms and Performance Events Reference 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MPLS_TUNNEL_UNEXPMEP

MPLS_TUNNEL_UNEXPMEP

Description

The MPLS_TUNNEL_UNEXPMEP is an alarm indicating an error of the tunnel OAM CCM information. The sink NE reports this alarm upon receiving an OAM packet (containing CCM information) with an unexpected MEP ID.

  1. The ingress NE adds a tunnel outgoing label to the OAM packet that contains the CCM information and sends the packet to the egress NE. CCM information includes the MEG level, MEG ID, and MEP ID of the ingress NE.
  2. The egress NE receives the OAM packet based on its incoming label and compares the CCM information in the packet with that configured on itself. If MEG levels and MEG IDs are consistent but MEP IDs are inconsistent, the egress NE reports the MPLS_TUNNEL_UNEXPMEP alarm.

Attribute

Alarm Severity Alarm Type

Major

Communication alarm

Parameters

When you view an alarm on the network management system, select the alarm. In the Alarm Details field display the related parameters of the alarm. The alarm parameters are in the following format: Alarm Parameters (hex): parameter1 parameter2...parameterN. For details about each parameter, refer to the following table.

Name Meaning

Parameter 1

(OptiX OSN 500/550)LSRID/MEGID: Indicates the source of the packet.

NOTE:
OptiX OSN 580 has no alarm parameters.

Impact on the System

When this alarm occurs, services are interrupted.

Possible Causes

The possible cause of the MPLS_TUNNEL_UNEXPMEP alarm is as follows:

Cause: MEP IDs are inconsistent on NEs at both ends of the tunnel.

As shown in Figure 4-24, NE2 is the source end for NE1 and the MEP ID on both NEs is 1.

However, the MEP ID of NE1 is set to 1 while that of NE2 is set to 2 in fact. Therefore, NE2 reports the MPLS_TUNNEL_UNEXPMEP alarm upon receiving the OAM packet (containing CCM information) with an incorrect MEP ID from NE1.

Figure 4-24  MPLS_TUNNEL_UNEXPMEP alarm detection

Procedure

  1. As shown in Figure 4-24, check whether tunnel configurations are consistent on the source and sink NEs. MEP IDs must be set to the same value on NEs at both ends of a tunnel.

    NOTE:

    The MEP IDs must be consistent on the source and sink NEs of a tunnel.

  2. If MEP IDs are inconsistent, change them to the same.
  3. Check whether the alarm is cleared. If the alarm persists, contact Huawei technical support engineers for a solution.

Related Information

None.

Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020975

Views: 76172

Downloads: 138

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next