No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Commissioning and Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring ML-PPP

Configuring ML-PPP

This section describes how to configure ML-PPP.

Changing the E1 Frame Format and Frame Mode for a Channelized STM-1

By default, the E1 frame format in a channelized STM-1 is CRC-4 multiframe and the frame mode is PCM31(CCS).

Prerequisites

  • You must be an NM user with NE administrator authority or higher.
  • The required board is already added on the NE panel.
Tools, Equipment, and Materials

U2000

Procedure

  1. Select the desired NE from the Object Tree in the NE Explorer. Choose Configuration > Interface Management > Path Configuration from the Function Tree.
  2. Set the required parameters.



  3. Click Apply.

Creating MP Groups

To allow an MLPPP link to carry MPLS tunnels, you need to create an MP group.

Prerequisites

  • You must be an NM user with NE operator authority or higher.
  • Multiple serial ports have been configured with the PPP protocol activated.
Tools, Equipment, and Materials

U2000

Procedure

  1. Select the desired NE from the Object Tree in the NE Explorer. Choose Configuration > Packet Configuration > Interface Management > MP Group Management from the Function Tree.
  2. Click the Basic Attributes tab.
  3. Click New.
  4. Set MP group parameters.



  5. Click OK. Then, close the operation result dialog box that is displayed.
Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020976

Views: 49519

Downloads: 409

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next