No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Commissioning and Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring F1 Data Interfaces

Configuring F1 Data Interfaces

This topic describes the parameters for configuring F1 data interfaces.

Table 2-202 list the parameters for configuring F1 data interfaces.

Table 2-202  Parameters for configuring F1 data interfaces

Field

Value Range

Description

No.

1-88

Default value: -

The No. (F1 Data Port) parameter specifies the numbers of the F1 data ports that have the same direction.

Data Channel 1

F1, Bid-BidType-PortID

Default value: -

The Data Channel (F1 Data Port) parameter specifies the uplink and downlink ports that pass through the F1 data. displays pass-through channel 1, namely, the source port of the data services at the local station.

After the data channel is cancelled, the services that pass through the F1 data port are interrupted.

Value description:
  • F1: Indicates the F1 data port of the NE.
  • Bid-BidType-PortID: Indicates a port that can be used to set a slot of the F1 data port.
Recommendations:

When using the F1 data port, you need to configure its route. That is, set the 64 Kbit/s data being added to or dropped from the NE, or passing through the NE.

Association with other parameters:

You can correctly set the F1 data ports that have the same direction only when the F1 port is not set to Transparent ECC Overhead Transmission.

Data Channel 2

F1, Bid-BidType-PortID

Default value: -

The Data Channel (F1 Data Port) parameter specifies the uplink and downlink ports that pass through the F1 data. displays pass-through channel 2, namely, the sink port of the data services at the local station.

After the data channel is cancelled, the services that pass through the F1 data port are interrupted.

Value description:
  • F1: Indicates the F1 data port of the NE.
  • Bid-BidType-PortID: Indicates a port that can be used to set a slot of the F1 data port.
Recommendations:

When using the F1 data port, you need to configure its route. That is, set the 64 Kbit/s data being added to or dropped from the NE, or passing through the NE.

Association with other parameters:

You can correctly set the F1 data ports that have the same direction only when the F1 port is not set to Transparent ECC Overhead Transmission.

Available Data Channel

-

Displays all the available data interfaces or optical interfaces.

Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020976

Views: 46600

Downloads: 387

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next