No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Commissioning and Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IP Addresses for NNI Ports

Configuring IP Addresses for NNI Ports

After setting the LSR ID of an NE, set the IP address of a port on the NE.

Prerequisites

  • You are an NM user with Administrators rights or higher.
  • The LSR ID of an NE is set.
  • In Basic Attributes, Port Mode must be set to Layer 3.

Context

When planning the IP addresses for NNI ports, adhere to the following principles:

  • The IP address of an NNI port can be an IP address of standard class A, B, or C (namely, an IP address within the range from 1.0.0.1 to 223.255.255.254). The IP address of an NNI port cannot be a broadcast address (*.*.*.255), multicast address (224.0.0.0 to 239.255.255.255), reserved address (240.0.0.0 to 255.255.255.255), network address (*.*.*.0), zero address (0.*.*.*), loopback address (127.*.*.*) or subnet address (192.168.*.* or 192.169.*.*).
  • Each NNI port must have an independent and globally unique IP address in a network.
  • The IP address of an NNI port must be different from the IP address of the NE. In addition, the IP address of an NNI port and the IP address of the NE must be in different network segments and must not overlap each other.
  • The LSR ID of an NE and the IP address of the NE must be different from each other and must be in different network segments.
  • The IP addresses of different ports on an NE must be in different network segments.
  • The IP addresses of the ports at both ends of a link must be in the same network segment.

Procedure

  1. In the NE Explorer, select the required NE, and then choose Configuration > Packet Configuration > Interface Management > Ethernet Interface from the Function Tree.
  2. Click the Layer 3 Attributes tab. Then, set the IP Address and IP Mask parameters. For the parameter description, see Layer 3 Attributes.

  3. Click Apply. In the Operation Result dialog box, which should display that the operation succeeded, click Close.
Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020976

Views: 45860

Downloads: 383

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next