No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Commissioning and Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Serial Port Parameters

Setting Serial Port Parameters

When some 64 kbit/s timeslots of a Smart E1 port are used for transmission of ATM services, these timeslots can be considered as a serial port.

Creating Serial Ports

When creating a serial port, you can set the 64 kbit/s timeslots to be bound with the serial port.

Prerequisites

  • You are an NM user with Administrators rights or higher.
  • The ports that carry services are set to Layer 1.
Tools, Equipment, and Materials

U2000

Procedure

  1. In the NE Explorer, select the required NE from the Object Tree and choose Configuration > Packet Configuration > Interface Management > Serial Interface from the Function Tree.
  2. Click the Basic Attributes tab.
  3. Click New.
    The New Serial Interface dialog box is displayed.

  4. Set the parameters for the serial port according to the planning information.
  5. Click OK. Then, close the dialog box that is displayed.

Setting Basic Attributes of Serial Ports

The basic attributes of serial ports involve the parameters such as port mode and encapsulation type.

Prerequisites

  • You are an NM user with Administrators rights or higher.
  • Serial ports are added.
Tools, Equipment, and Materials

U2000

Procedure

  1. In the NE Explorer, select the required NE from the Object Tree and choose Configuration > Packet Configuration > Interface Management > Serial Port from the Function Tree.
  2. Click the Basic Attributes tab.
  3. Select the required port and set the parameters for the serial port according to the planning information.
  4. Click Apply. Then, close the dialog box that is displayed.
Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020976

Views: 50377

Downloads: 409

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next