No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Commissioning and Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Modifying the Board Configuration Data

Modifying the Board Configuration Data

You can modify the existing board configuration data.

Adding Boards

When manually configuring the NE data, you need to add the boards to the NE panel. You can add the physical boards that actually operate on the NE or the logical boards that do not exist on the NE to the NE panel.

Prerequisites

  • The NE must be created.
  • There must be idle slots on the NE panel.
  • You are an NM user with Maintenance Group rights or higher.
Background Information
  • The physical boards are the actual boards inserted in the subrack. The logical boards are created on the U2000 and are saved on the SCB board, but they do not exist on the actual equipment.
  • The NE panel shows the mapping relations between the slots that house the processing boards and the slots that house the interface boards. If you click a processing board that is paired with an interface board on the NE panel, the ID of the slot that houses the mapping interface board is displayed in orange.

Procedure

  1. Double-click the icon of the NE to open the NE panel.
  2. Right-click the selected idle slot. Select the board you need to add from the drop-down list.

    NOTE:
    If the physical cross-connect board is installed in the subrack, add its corresponding logical board on the U2000.

Deleting Boards

To modify the network configuration or the NE configuration, you need to delete the boards from the NE panel.

Prerequisites

  • The services and protection groups must be deleted.
  • You are an NM user with Maintenance Group rights or higher.

Procedure

  1. Double-click the icon of the NE to display the NE Panel.
  2. Right-click the board you need to delete and choose Delete from the shortcut menu.
  3. Click OK in the Delete Board dialog boxes that are displayed sequentially.

Modifying Board Configuration Parameters

You can modify the existing board configuration data.

Prerequisites

To change the values of different configuration parameters of different boards, you may need to operate as NM users with different authorities. You are an NM user with Operator Group rights or higher.

Procedure

  1. In the NE Explorer, select a board and choose the appropriate function entry from the Function Tree.

    Board Type

    Parameter

    SDH board

    Laser Switch, Optical(Electrical) Interface Loopback, VC4 Loopback

    PDH board

    Tributary Loopback, Service Load Indication, Re-timing Mode

    Ethernet board

    Port enabling, working mode, maximum frame length, MAC loopback, PHY loopback, TAG, entry test

  2. In the pane on the right, modify the existing parameter settings and click Apply.
Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020976

Views: 45499

Downloads: 378

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next