No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Commissioning and Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating VLANs Filtering

Creating VLANs Filtering

In the case of Ethernet LAN services, when an IEEE 802.1q or IEEE 802.1ad bridge is created, the VLAN filtering table needs to be created for the bridge, if VLANs are used to isolate the data of different users.

Prerequisites

  • The bridge and mount ports must be created.
  • Bridge Switch Mode must be set to IVL/Ingress Filter Enable.
  • You are an NM user with Operator Group rights or higher.

Procedure

  1. In the NE Explorer, select an Ethernet board and choose Configuration > Ethernet Service > Ethernet LAN Service from the Function Tree. Click the VLAN Filtering tab.
  2. Click New. Then, the Create VLAN dialog box is displayed. Enter VLAN ID, select Available forwarding ports, and then click .

  3. Click OK. Then, click Close in the Operation Result dialog box that is displayed.
  4. Create other VLAN filtering tables according to the requirements.
Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020976

Views: 46711

Downloads: 387

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next