No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OSN 500 550 580 V100R008C50 Commissioning and Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the LSR ID for an NE

Configuring the LSR ID for an NE

Label switch router (LSR) IDs are used to identify nodes on the MPLS network. In the MPLS network, LSR IDs are configured for identifying source and sink nodes of MPLS tunnels.

Prerequisites

You are an NM user with Administrators rights or higher.

Context

When planning the LSR ID for an NE, adhere to the following principles:

  • The IP address of an NNI port can be an IP address of standard class A, B, or C (namely, an IP address within the range from 1.0.0.1 to 223.255.255.254). The IP address of an NNI port cannot be a broadcast address (*.*.*.255), multicast address (224.0.0.0 to 239.255.255.255), reserved address (240.0.0.0 to 255.255.255.255), network address (*.*.*.0), zero address (0.*.*.*), loopback address (127.*.*.*) or subnet address (192.168.*.* or 192.169.*.*). The network segment 130.0.0.0 is recommended.
  • Each NE must have an independent and globally unique LSR ID on a network.
  • The LSR ID of an NE and the IP address of the NE must be different from each other and must be in different network segments.
  • The SLR ID of an NE must be in a different network segment from the IP address of any service port on the NE.

Procedure

  1. In the NE Explorer, select the NE and choose Configuration > Packet Configuration > MPLS Management > Basic Configuration from the Function Tree.
  2. Set LSR ID.

    For details about LSR ID, see Basic Configuration.

    NOTE:
    • When the LSR ID is specified for the first time, no warm-reset occurs on the NE. If the specified LSR ID is then changed, a warm-reset occurs on the NE but does not affect services.
    • If any tunnel exists, do not suggest to change the LSR ID.

Translation
Download
Updated: 2019-01-21

Document ID: EDOC1100020976

Views: 51121

Downloads: 415

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next