No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


PowerCube 500 System Configuration Guide (PC500-300H1, PC500-300G1, EG6P-150G1)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Preemption Mode

Configuring the Preemption Mode

This topic describes how to configure the preemption mode for port blocking after an NE is reset.


  • You must be an NM user with NE operator authority or higher.

  • SEP Protection Instance has been created.

Tools, Equipment, and Materials

Web-based NMS.


  1. Choose Configuration > Sep Management.
  2. Choose the SEP protection instance, Click Preemption Mode and select a preemption mode.

Updated: 2019-04-26

Document ID: EDOC1100021621

Views: 21826

Downloads: 244

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next