No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

PowerCube 500 System Configuration Guide (PC500-300H1, PC500-300G1, EG6P-150G1)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Process

Configuration Process

To use the LAG protocol, you need to configure a LAG. In addition, you can configure the priorities of the ports in the LAG as required.

Figure 5-1 Process of configuring LAG
Table 5-1 Procedure for configuring a LAG
Step Operation Description
1 Creating a LAG

Required. Set the major parameters as follows:

  • Set LAG Type to the same value as the opposite equipment. Generally, set LAG Type to Static for the equipment at both ends.
  • Set Load Sharing to the same value as the opposite equipment. If the LAG is configured to provide protection, it is recommended that you set Load Sharing to Non-Sharing for the equipment at both ends. If the LAG is configured to increase bandwidths, it is recommended that you set Load Sharing to Sharing for the equipment at both ends.
  • Set Revertive to the same value as the opposite equipment. Generally, set Revertive to Revertive for the equipment at both ends. This parameter is valid only to the non-sharing LAG.
  • Set Main Port and Selected Standby Ports according to the planning information. It is recommended that the main and slave ports at both ends adopt the same settings.
2 Setting LAG Parameters

Optional.

Unless otherwise specified, adopt the default values of Port Priority.

Translation
Download
Updated: 2019-04-26

Document ID: EDOC1100021621

Views: 26726

Downloads: 295

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next