No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

PowerCube 500 System Configuration Guide (PC500-300H1, PC500-300G1, EG6P-150G1)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IEEE 802.1d Bridge-based E-LAN Services

Configuring IEEE 802.1d Bridge-based E-LAN Services

This section uses an IEEE 802.1d bridge-based E-LAN service as an example to describe how to configure Ethernet services according to the service plan.

Networking Diagram

As shown in Figure 2-5, the PowerCube 500 needs to transmit Ethernet services from the Camera to the upper-layer network based on IEEE 802.1d bridge-based E-LAN services.

Figure 2-5 Networking diagram for configuring IEEE 802.1d bridge-based E-LAN services

Data Preparation

The following table describes the data planned for the configuration.

Table 2-6 Data planned for the configuration

Item

Parameter

Value in This Example

Planning Guidelines

Setting the basic attributes of the ports

Port Enabled

Enabled

Set this parameter to Enabled.

Encapsulation Type

Null

Set this parameter to Null when configuring IEEE 802.1d bridge-based E-LAN services.

Working Mode

Auto-Negotiation

Set this parameter to the same value as that at the peer end. Typically, this parameter is set to Auto-Negotiation at the peer end.

Configuring an IEEE 802.1d bridge-based E-LAN service

Service ID

1

Value range: 1 to 1024.

Service Name

ELAN

-

Tag Type

Tag-Transparent

Set this parameter to Tag-Transparent when configuring IEEE 802.1d bridge-based E-LAN services.

MAC Address Learning Mode

SVL

Set this parameter to SVL when configuring IEEE 802.1d bridge-based E-LAN services.

UNI Port

2-EG8P-3(PORT-3)

2-EG8P-4(PORT-4)

Set this parameter according to the service plan.

Others

Default value

-

Procedure

  1. Set the basic attributes of the ports.



  2. Configure an IEEE 802.1d bridge-based E-LAN service.



Translation
Download
Updated: 2019-04-26

Document ID: EDOC1100021621

Views: 21270

Downloads: 238

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next