No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

PowerCube 500 System Configuration Guide (PC500-300H1, PC500-300G1, EG6P-150G1)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Process (Networking with only PC500s)

Configuration Process (Networking with only PC500s)

The core of the SEP is to create a new SEP protection instance.

Figure 3-1 Process of configuring SEP
Table 3-1 Procedure for configuring a SEP

Step

Operation

Description

1

Creating SEP Protection Instances

Mandatory. Set parameters as follows:

  • Set Instance ID, East Port, East Port Configuration Role, West Port, East Port Configuration Role, Control VLAN, Preemption Delay(s), TC Suppression Time Interval(s), and Authentication according to the network plan.
  • When setting Control VLAN, note the following:
    • In a SEP segment, the control VLAN is used to transmit only SEP packets.
    • Each SEP segment must have a control VLAN.
    • If different ports are configured with different SEP segments, they can use the same control VLAN.
    • If different ports are configured with different SEP segments, they can use the same control VLAN.
  • Because the switch does not support authentication, set Authentication Type to No Authentication.

2

Configuring the Port Blocking Mode

Optional.

Configure the Port Blocking Mode as planned. Generally, the default value is recommended.

3

Configure the port priority

Optional.

Configure the user-defined Priority as planned. Generally, the default value is recommended.

NOTE:
The higher the value, the higher the priority.

4

Configuring the Preemption Mode

Optional.

Configure the Preemption Mode as planned. Generally, the default value is recommended.

NOTE:
Only the master node supports the preemption mode configuration.
Translation
Download
Updated: 2019-04-26

Document ID: EDOC1100021621

Views: 21626

Downloads: 241

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next