No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

PowerCube 500 System Configuration Guide (PC500-300H1, PC500-300G1, EG6P-150G1)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Traffic Control of Ethernet Ports

Configuring the Traffic Control of Ethernet Ports

After traffic control is enabled, the Ethernet port sends the pause frame to instruct the peer end to stop sending Ethernet packets for a period if the link is congested, eliminating link congestion.

Prerequisites

You have logged in to the NE.

Tool

Web-based NMS (Internet Explorer 9.0 or later)

Procedure

  1. Configure the Ethernet port traffic control.

    NOTE:
    • Auto-Negotiation Flow Control Mode is valid only when Working Mode is set to Auto-Negotiation.

    • Non-Autonegotiation Flow Control Mode is valid only when Working Mode is not set to Auto-Negotiation.

Translation
Download
Updated: 2019-04-26

Document ID: EDOC1100021621

Views: 22952

Downloads: 250

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next