No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionAccess V100R006C20 on FusionCloud V100R006C10 Software Installation Guide 11 (Microsoft AD)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



This section describes how to construct ITA alarms and verify that whether ITA alarms can be reported to FusionManager.


  • You have obtained the account and password for logging in to FusionAccess.
  • You have obtained the account and password for logging in to FusionManager.


  1. Log in to FusionAccess, choose System > Initial Configuration > Alarm Components, and configure an unavailable IP address for DHCP.
  2. After the DHCP Server Abnormal alarm is generated on FusionAccess, log in to FusionManager and check whether the alarm generated by ITA is reported to FusionManager.
  3. Repeat the preceding steps to create other alarms on the ITA node and check whether the alarms can be reported to FusionManager.
Updated: 2019-07-01

Document ID: EDOC1100021785

Views: 47567

Downloads: 102

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next