No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionAccess V100R006C20 on FusionCloud V100R006C10 Software Installation Guide 11 (Microsoft AD)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Modifying the application.properties File on the ITA node

Modifying the application.properties File on the ITA node

Scenarios

This section describes how to modify the alarm.properties file on the ITA node.

Prerequisites

  1. Log in to the ITA node using VNC and run the following command to open the alarm.properties configuration file:

    vi /opt/ITA/tomcat/ita/WEB-INF/classes/alarm.properties

  2. Press I to enter the editing mode and change the IP address to the IP address of the DMZ_Tenant network segment on the FusionManager node.

  1. Press Esc to exit the editing mode, enter :wq, and press Enter.
  2. Run the following command to restart the ITA service:

    service ITAService restart

Translation
Download
Updated: 2019-07-01

Document ID: EDOC1100021785

Views: 49677

Downloads: 112

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next