No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionAccess V100R006C20 on FusionCloud V100R006C10 Software Installation Guide 11 (Microsoft AD)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Alarm Components

Configuring Alarm Components

Scenarios

This section describes how to configure IP addresses and enable the alarm function of components on FusionAccess, and monitor components using FusionAccess.

NOTE:
  • When the customer's existing AD system is used, the customer ensures the reliability of AD, DNS, and DHCP. FusionAccess does not monitor these components, so this configuration task is not required.
  • When a new Windows AD, DNS, or DHCP server is used:
    • If you want to monitor alarms of the DNS or DHCP server or enable the DNS or DHCP backup, install a monitoring agent on the server.
    • If you want to monitor alarms of the AD server, enable status monitoring and install a monitoring agent on the server.

Prerequisites

You have logged in to the current tenant's FusionAccess management system.

Procedure

Configuring the AD alarm

  1. Log in to the current tenant's FusionAccess using a browser.

    For details, see Logging In to FusionAccess.

  2. On the FusionAccess page of the current tenant, choose System > Initial Configuration > Domain/OU.
  3. In the Domain Configuration area, click in the Operation column.
  4. Set Enable alarm to Yes.

Configuring other alarm components

  1. On the FusionAccess portal, choose System > Initial Configuration > Alarm Components.

    The Alarm Components page is displayed.

  2. Configure alarm information.

    Table 5-20 lists the parameters, and Figure 5-45 describes a configuration example.

    Table 5-20 Data required for performing this operation

    Type

    Parameter

    Description

    Enable alarm

    Enable alarm

    • Yes: enables component status monitoring by FusionAccess. FusionAccess monitors Backup Server, ITA, GaussDB, License, HDC, WI, vAG, vLB, UNS, and AUS in the environment. If you want to monitor DNS, DHCP, RD Licensing, or domain controllers, configure the IP address.
    • No: disables alarm monitoring.

    DNS/DHCP/RD Licensing

    Active DNS IP

    IP address of the active DNS server

    Standby DNS IP

    IP address of the standby DNS server

    Active DHCP IP

    IP address of the active DHCP server

    Standby DHCP IP

    IP address of the standby DHCP server

    RD Licensing IP

    IP address of the RD Licensing server (Optional and configured in SBC scenarios only)

    Figure 5-45 Alarm Components

  3. After alarm information is configured, click OK.
Translation
Download
Updated: 2019-07-01

Document ID: EDOC1100021785

Views: 45432

Downloads: 100

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next