About This Document
Intended Audience
This document describes the appearance, functions, structure, and parameters of the 9008 V5, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
You can perform installation, removal, power-on, power-off, basic configuration, OS installation, parts replacement, and troubleshooting of the KunLun 9008 V5 by referring to this document.
- Huawei technical support engineers
- Technical support engineers from channel partners
- Enterprise administrators
Symbol Conventions
The symbols that may be found in this document are defined as follows:
Symbol |
Description |
---|---|
Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. |
|
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. |
|
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. |
|
Indicates a potentially hazardous situation which, if not avoided, could result in equipment damage, data loss, performance deterioration, or unanticipated results. NOTICE is used to address practices not related to personal injury. |
|
Calls attention to important information, best practices and tips. NOTE is used to address information not related to personal injury, equipment damage, and environment deterioration. |
Change History
Changes between document issues are cumulative. The latest document issue contains all changes made in previous issues.
Issue 13 (2020-09-25)
The issue is the thirteenth official release.
- Modified the Front Panel Components and Technical Specifications.
- Added the Switching Between BPU A and BPU B.
Issue 12 (2020-08-11)
The issue is the twelfth official release.
Modified the SCM-A and Memory Subsystem Architecture.
Issue 11 (2020-04-16)
The issue is the eleventh official release.
Modified the FusionServer Tools SmartKit.
Issue 10 (2020-03-20)
The issue is the tenth official release.
Modified the Powering On the Server (without a CME) to Logging In to a Server Using the Remote Virtual Console.
Issue 09 (2020-03-02)
The issue is the ninth official release.
Modified the SATA/SAS Hard Disk, SATA/SAS Hard Disk, NVMe SSD, Hard Disk (Switch Module) and the Physical Specifications.
Issue 08 (2019-12-05)
The issue is the eighth official release.
Modified the Default Data and the Switching from Single-system Mode to Dual-system Mode.
Issue 07 (2019-05-20)
The issue is the seventh official release.
Added the SCM-D and SCM-E.
Issue 06 (2019-01-07)
The issue is the sixth official release.
Modified the logical partition deployment topology in (Optional) Configuring Logical Partitions.
Issue 05 (2018-11-29)
The issue is the fifth official release.
Added the operational procedure of updating the kernel version in Hot-Swappable PCIe Card.
Issue 04 (2018-11-15)
The issue is the fourth official release.
Refreshed PSU specifications.
Issue 03 (2018-10-30)
The issue is the third official release.
Added the full hot swap BIO module (V5-BIO-B).
Issue 02 (2018-08-06)
The issue is the second official release.
Added the contents of 9008 V5 (with a CME).
Issue 01 (2018-06-01)
The issue is the first official release.