No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionAccess V100R006C20 on FusionCloud 6.3.x Software Installation Guide 11 (LiteAD)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Obtaining UVP VMTools

Obtaining UVP VMTools

Scenarios

This section describes how to obtain UVP VMTools.

Prerequisites

  • You have obtained the FusionSphere OpenStack V100R00xCxx_Tool.tar.gz file.
  • You have obtained the address, username, and password for logging in to the FusionSphere OpenStack web client.
    • Region Type I scenario: Log in to the cascading FusionSphere OpenStack web client.
    • Region Type II scenario: Log in to the FusionSphere OpenStack web client.

Procedure

  1. On the local PC, decompress the FusionSphere OpenStack V100R00xCxx_Tool.tar.gz file using 7-Zip.
  2. Go to the UVPVMTools folder, decompress the VMTOOLSV200R005C00SPCxxxBxxx.zip package, and obtain the VMTOOLSV200R005C00SPCxxxBxxx.tar.gz file.
  3. Select an operating platform based on the Region Type scenario.

    • In the Region Type I scenario, log in to the cascading FusionSphere OpenStack web client.
    • In the Region Type II scenario, log in to the FusionSphere OpenStack web client.

  4. Choose O&M > Service Package Mgmt and upload the VMTOOLSV200R005C00SPCxxxBxxx.tar.gz installation package.
  5. NOTE:

    The following steps only apply to FusionCloud 6.3.0.

    Choose Configuration > Role. On the role configuration page, select all hosts in the AZ for creating images and add the VMTools role.
    1. On the role configuration page, scroll to the bottom of the page and select hosts for which you want to add the VMTools role. You can select a maximum of two hosts at a time.
    2. After selecting the host, find the VMTools role in System Role Management Workspace on the right and drag the role to the corresponding host in Role Configuration Workspace.
    3. Click .
    4. Repeat steps 5.a to c to add the VMTools role to other hosts.

Translation
Download
Updated: 2019-07-01

Document ID: EDOC1100026752

Views: 29152

Downloads: 39

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next