No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Feature Description - VPN 01

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PW Side Receiving a Loop Detection Packet

PW Side Receiving a Loop Detection Packet

Figure 14-5  PW side receiving a loop detection packet

In Figure 14-5, PE1's AC interface is an Ethernet interface. After the AC interface goes physically Up, it proactively sends a loop detection packet. If this packet loops back to PE1 through Switch, PE2, and the PW between PE1 and PE2, a loop occurs on the network. PE1 then sets the link layer protocol of the AC interface to Down and reports an alarm to the NMS. This mechanism prevents the AC interface from sending or receiving any packets.

Updated: 2018-07-04

Document ID: EDOC1100027166

Views: 42687

Downloads: 166

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next