No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an MPLS MTU on an Interface

Configuring an MPLS MTU on an Interface

An MPLS MTU can be configured on an interface to determine the maximum number of bytes in an MPLS packet that an interface can forward without fragmenting the packet.

Context

The MPLS MTU is a forwarding plane parameter and is irrelevant to LSP establishment. The dependency between the MPLS MTU and the interface MTU is as follows:

  • If no MPLS MTU is set and an interface MTU is set on an interface, the interface MTU is used.

  • If an MPLS MTU and an interface MTU are set on an interface, the smaller value between the MPLS MTU and interface MTU is used.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The view of an MPLS-enabled interface is displayed.

  3. Run:

    mpls mtu mtu

    An MPLS MTU is set on the interface.

    The configured MPLS MTU takes effect immediately, and there is no need to restart the interface.

    NOTE:

    If the MPLS MTU configured using the mpls mtu command is used as the MPLS forwarding MTU, run the mpls path-mtu independent command to allow the MPLS MTU to take effect without being affected the interface MTU. The mpls path-mtu independent command is used when a Huawei device communicates with a non-Huawei device, which prevents low MPLS forwarding efficiency stemming from different MTU implementations.

  4. Run:

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101490

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next