No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configurations

Checking the Configurations

After you adjust MPLS parameters, view MPLS-enabled interface information.

Prerequisites

MPLS parameters have been adjusted.

Procedure

  1. Run the display mpls rsvp-te interface [ interface-type interface-number ] command to check MPLS TE-enabled interface information, including the interface MTU.
  2. Run the display mpls ldp interface [ interface-type interface-number | verbose ] command to check MPLS LDP-enabled interface information, including the interface MTU.
  3. Run the display mpls interface [ interface-type interface-number ] [ verbose ] command to check MPLS-enabled interface information.

Example

If the configuration is successful, run the preceding commands to obtain the following information. The command output shows that the effective MPLS MTU value is 1200.

<HUAWEI> display mpls rsvp-te interface
Interface: GigabitEthernet1/0/1
 Interface Address: -----
 Interface state: DOWN                        Interface Index: 0x6
 Total-BW: 0                                  Used-BW: 0
 Hello configured: NO                         Num of Neighbors: 0
 SRefresh feature: DISABLE                    SRefresh Interval: 30 sec
 Mpls Mtu: 1200                              Retransmit Interval: 5000 msec
 Increment Value: 1
 Authentication: DISABLE
 Bfd Enabled: DISABLE                         Bfd Min-Tx: 10
 Bfd Min-Rx: 10                               Bfd Detect-Multi: 3
 RSVP instance name: RSVP0
<HUAWEI> display mpls ldp interface verbose
     LDP Interface Information in Public Network
 --------------------------------------------------------------
 Interface Name    : GigabitEthernet1/0/1
 LDP ID            : 0.0.0.0:0         Transport Address : 0.0.0.0
 Entity Status     : Inactive          Effective MTU    : 1200

 Configured Hello Hold Timer     : 15 Sec
 Negotiated Hello Hold Timer     : 15 Sec
 Configured Hello Send Timer     : ---
 Configured Keepalive Hold Timer : 45 Sec
 Configured Keepalive Send Timer : ---
 Configured Delay Timer     : 10 Sec
 Label Advertisement Mode   : Downstream Unsolicited
 Hello Message Sent/Rcvd    : 0/0 (Message Count)
 Autoconfiguration Source   : ---
 -------------------------------------------------------------
<HUAWEI> display mpls interface verbose
No                    : 1
Interface             : GigabitEthernet1/0/0
Status                : Up
TE Attribute          : Enable
MPLS MTU              : 1200
Interface MTU         : 1500
Effective MTU         : 1200
TE FRR                : Disable
Interface Index       : 0x18000206
Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102710

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next