No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MPLS TE

Enabling MPLS TE

Before you set up a static CR-LSP, enable MPLS TE.


Perform the following steps on each node along a static CR-LSP:


  1. Run:


    The system view is displayed.

  2. Run:


    The MPLS view is displayed.

  3. Run:

    mpls te

    MPLS TE is enabled on the node globally.

    Before you enable MPLS TE on each interface, enable MPLS TE globally in the MPLS view.

  4. Run:


    Return to the system view.

  5. Run:

    interface interface-type interface-number

    The interface view is displayed.

  6. Run:


    The MPLS is enabled on the interface.

  7. Run:

    mpls te

    The MPLS TE is enabled on the interface.


    When the MPLS TE is disabled in the interface view, all CR-LSPs on the current interface go Down.

    When the MPLS TE is disabled in the MPLS view, the MPLS TE on each interface is disabled, and all CR-LSPs are torn down.

  8. Run:


    The configurations are committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102131

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next