No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Ingress of the Static CR-LSP

Configuring the Ingress of the Static CR-LSP

This section describes how to configure the ingress of a static CR-LSP. Before you establish a static CR-LSP, specify the ingress of the CR-LSP.


Perform the following steps on the ingress of a static CR-LSP:


  1. Run:


    The system view is displayed.

  2. Run:

    static-cr-lsp ingress { tunnel-interface tunnel interface-number | tunnel-name } destination destination-address { nexthop next-hop-address | outgoing-interface interface-type interface-number } * out-label out-label [ bandwidth [ ct0 ] bandwidth ]

    The LSR is set as the ingress of the specified static CR-LSP.

    To modify the destination destination-address, nexthop next-hop-address, outgoing-interface interface-type interface-number, or out-label out-label, run the static-cr-lsp ingress command to set a new value. There is no need to run the undo static-cr-lsp ingress command before changing a configured value.

    tunnel interface-number specifies the MPLS TE tunnel interface that uses this static CR-LSP. By default, the Bandwidth Constraints value is ct0, and the value of bandwidth is 0. The bandwidth used by the tunnel cannot be higher than the maximum reservable bandwidth of the link.

    The next hop or outgoing interface is determined by the route from the ingress to the egress. For the difference between the next hop and outbound interface, see "Static Route Configuration" in HUAWEI NetEngine40E Universal Service Router Configuration Guide - IP Routing.

    If an Ethernet interface is used as an outbound interface, the nexthop next-hop-address parameter must be configured.

  3. Run:


    The configurations are committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102919

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next