Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Egress of the Static CR-LSP
This section describes how to configure the egress of a static CR-LSP. Before you set up a static CR-LSP, specify the egress of the CR-LSP.
Procedure
- Run:
system-viewThe system view is displayed.
- Run:
static-cr-lsp egress lsp-name incoming-interface interface-type interface-number in-label in-label [ lsrid ingress-lsr-id tunnel-id tunnel-id ]
The LSR is configured as the egress of the specified static CR-LSP.
To modify the incoming-interface interface-type interface-number or in-label in-label-value, run the static-cr-lsp egress command to set a new value. There is no need to run the undo static-cr-lsp egress command before changing a configured value.
- Run:
commitThe configurations are committed.
Previous
