No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Link Bandwidth

(Optional) Configuring Link Bandwidth

This section describes how to configure link bandwidth so that nodes can reserve the configured link bandwidth for a CR-LSP to be established.

Context

Plan bandwidths on links before you perform this procedure. The reserved bandwidth must be higher than or equal to the bandwidth required by MPLS TE traffic. Perform the following steps on each node along the CR-LSP to be established:

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The MPLS-TE-enabled interface view is displayed.

  3. Run:

    mpls te bandwidth max-reservable-bandwidth bw-value

    The maximum available link bandwidth is configured.

  4. Run:

    mpls te bandwidth bc0 bc0-bw-value

    The BC0 link bandwidth is configured.

  5. Run:

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102053

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next