No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Ingress of a Static Bidirectional Co-routed LSP

Configuring the Ingress of a Static Bidirectional Co-routed LSP

The ingress of a static bidirectional co-routed LSP needs to be manually specified.


Perform the following steps on the ingress of a static bidirectional co-routed LSP:


  1. Run:


    The system view is displayed.

  2. Run:

    bidirectional static-cr-lsp ingress tunnel-name

    A static bidirectional co-routed LSP is created, and the static bidirectional LSP view is displayed.

  3. Run:

    forward { nexthop next-hop-address | outgoing-interface interface-type interface-number } * out-label out-label-value [ bandwidth ct0 bandwidth ]

    A CR-LSP is configured on the ingress.

    The bandwidth parameter specifies the reserved bandwidth for a forward CR-LSP. The bandwidth value cannot be higher than the maximum reservable link bandwidth. If the specified bandwidth is higher than the maximum reservable link bandwidth, the forward CR-LSP cannot go Up.

  4. Run:

    backward in-label in-label-value [ lsrid ingress-lsr-id tunnel-id ingress-tunnel-id ]

    A reverse CR-LSP is specified on the ingress.

  5. (Optional) Run:

    description text

    A description is configured for the static bidirectional co-routed CR-LSP.

  6. Run:


    The configuration is committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101540

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next