No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MPLS TE and RSVP-TE

Enabling MPLS TE and RSVP-TE

Enabling MPLS TE and RSVP-TE on each node and interface in an MPLS domain is the prerequisites for all TE features.


  1. Run:


    The system view is displayed.

  2. Run:

    mpls lsr-id lsr-id

    An LSR ID is set for a local node.

    Note the following issues when setting an LSR ID:
    • LSR IDs must be set before other MPLS commands are run.

    • No default LSR ID is available.

    • Using the IP address of a loopback interface as the LSR ID is recommended for an LSR.

  3. Run:


    The MPLS view is displayed.

  4. Run:

    mpls te

    MPLS TE is enabled globally.

  5. Run:

    mpls rsvp-te

    RSVP-TE is enabled.

  6. Run:


    The system view is displayed.

  7. Run:


    The configuration is committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 103109

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next