No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic BFD For Initiated RSVP-TE LSP

Configuring Dynamic BFD For Initiated RSVP-TE LSP

LSPs that a controller runs the PCE Initiated LSP protocol to establish can only be monitored by dynamic BFD.



Configuring dynamic BFD to monitor RSVP-TE Initiated LSPs is recommended. If no BFD session is configured, the LSP goes Up by default, but its actual status cannot be determined.


  1. Run:


    The system view is displayed.

  2. Run:


    The MPLS view is displayed.

  3. Run:

    mpls te bfd enable auto-primary-tunnel pce-initiated-lsp

    Dynamic BFD to monitor RSVP-TE Initiated LSP is enabled globally.

  4. Run:


    The configuration is committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101613

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next