No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
MENU
Support Documentation

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Dynamic BFD for Initiated RSVP-TE Tunnel

Configuring Dynamic BFD for Initiated RSVP-TE Tunnel

RSVP-TE tunnels that a controller runs the PCE Initiated LSP protocol to establish can only be monitored by dynamic BFD.

Context

NOTE:

Configuring dynamic BFD to monitor RSVP-TE Initiated tunnels is recommended. If no BFD session is configured, the tunnel goes Up by default, but its actual status cannot be determined.

Procedure

  1. Run: 

    system-view

    The system view is displayed.

  2. Run: 

    mpls

    The MPLS view is displayed.

  3. Run: 

    mpls te bfd tunnel enable auto-primary-tunnel pce-initiated-lsp

    Dynamic BFD for initiated RSVP-TE tunnel is enabled globally.

  4. Run: 

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102693

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next
Enterprise APP

Copyright © 2019 Huawei Technologies Co., Ltd. All rights reserved.