No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Specifying a Candidate Server for a PCE Client

Specifying a Candidate Server for a PCE Client

Candidate servers can be specified for a PCE client to provide redundancy, which improves network reliability.

Usage Scenario

PCE+ devices are classified as servers and clients. A client sends a request to the server to calculate a path, and the server calculates a path. To specify a candidate PCE server for a PCE client, run the connect-server command.

Multiple candidate PCE servers can be specified for a PCE client.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    pce-client

    The PCE client view.

  3. Run:

    connect-server ip-address

    A candidate server is specified for the PCE client.

    The ip-address value is set to the source IP address of a PCE server. Repeat this step to specify multiple candidate servers to provide redundancy.

  4. (Optional) Run:

    preference preference

    A preference value is assigned to a candidate PCE server.

    The preference value is an integer ranging from 0 to 7. The greater the value, the higher the preference.

    When multiple candidate servers are specified for a single client, they can be prioritized. A candidate server with the highest preference is selected to calculate paths.

    If no preference value is set, the default value 0 is used, indicating the lowest preference. If candidate servers have the same preference, the server with the smallest IP address is selected to calculate paths.

  5. Run:

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101240

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next