No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the IP-Prefix Tunnel Function

Configuring the IP-Prefix Tunnel Function

The ip-prefix tunnel function can be configured and used to establish P2P TE tunnels in a batch, which simplifies the configuration.

Usage Scenario

When you want to create a large number of P2P TE tunnels or create P2P TE tunnels to form a full-mesh network, creating them one by one is laborious and complex. To simplify MPLS TE tunnel configuration, configure the ip-prefix tunnel function so that P2P TE tunnels can be established in a batch.

The full-mesh network indicates that a P2P TE tunnel is established between any two nodes on a network.

Pre-configuration Tasks

Before configuring the ip-prefix tunnel function, complete the following tasks:

Configuration Procedures

Figure 3-4  Flowchart for configuring the ip-prefix tunnel function
Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102252

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next