No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an IP Prefix List

Configuring an IP Prefix List

An IP prefix list can be configured to define destination IP addresses used in the ip-prefix tunnel function.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    ip ip-prefix ip-prefix-name [ index index-number ] { permit | deny } ip-address mask-length [ greater-equal greater-equal-value ] [ less-equal less-equal-value ]

    An IPv4 prefix list is configured.

    The ip-prefix-name parameter specifies destination IP addresses that can or cannot be used to establish a P2P TE tunnels.

  3. Run:

    commit

    The configuration is committed.

Download
Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 101564

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next