No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


NE40E V800R010C00 Configuration Guide - MPLS 01

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling P2MP TE on an Interface

(Optional) Disabling P2MP TE on an Interface

You can disable P2MP TE on a specific interface during the network planning.


By default, after P2MP TE is globally enabled, P2MP TE is automatically enabled on each MPLS TE-enabled interface on a local node. To disable P2MP TE on a specific interface during network planning or there is no need to have P2MP TE enabled on a specific interface because it does not support P2MP forwarding, disable P2MP TE on the specific interface.


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    mpls te p2mp-te disable

    P2MP TE is disabled on the interface.

    After the mpls te p2mp-te disable command is run, P2MP TE LSPs established on the interface are torn down, and newly configured P2MP TE LSPs on the interface fail to be established.

  4. Run:


    The configuration is committed.

Updated: 2018-07-12

Document ID: EDOC1100028530

Views: 102049

Downloads: 336

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next